Type write erase to issue the erase comment.Connect to the Cisco ASA 5512-X IPS with the serial over ethernet cable. Note 3: If you just want to reset the configuration and you haven’t lost access to the device, follow steps 1 and 2, and then skip down to the bottom. Again, please proceed with absolute care if you are using this guide on anything that is not a Cisco ASA 5512-X IPS.By looking at the details of your devices, configuration can help you identify the cause to your problem. Issue the show running configuration command to find out the whole configuration your Cisco devices use while operating. Show Running-Config and Show Startup-Config Commands.It is Cisco’s largest and longest-running Cisco Corporate Social Responsibility program. Cisco Networking Academy is a global IT and cybersecurity education program that partners with learning institutions around the world to empower all people with career opportunities.Unlike on a router or switch where the start up configuration is stored as a file call 'config.text' in the flash: file system, ont he ASA is hidden unless you specify the location of the file using the command 'boot config x'. The start up configuration on an ASA is not stored in a obvious place unless configured to be stored like that.Both the VPN settings mentioned above and the enable/passwd are not salted, contrary to what the thread suggests in Peleus's post.

The Cisco ASA config you have provided appears to use CISCO PIX-MD5 hashes.

Otherwise the default username and password is to leave both blank. DHCP is enabled on the cisco device, and it's internal IP address is now 192.168.1.1! If you had an enable password set, you may need to enter that in the password box when you try to connect using the ASDM.

The Cisco ASA has been reset to factory settings.

We got talking about ASA 9.0 clustering on a podcast recording we did over the weekend, and we hit a few points based on the official Cisco configuration guide. One of the new features Cisco is touting is firewall clustering.

Cisco has released OS version 9.0.1 for the popular and ubiquitous ASA firewall.

In short, you can inject and trace a packet as it progresses through the security features of the Cisco ASA appliance and quickly determine wether or not the packet will pass.

Packet-tracer in Cisco ASA – simulated traffic Cisco ASA includes a very nice feature since the 7.2(1)-release packet-tracer.

On ASA, you can use 'erase startup-config' to clear the startup configuration and 'configure factory-default' to restore the factory default configuration.

With ASA firewalls, there is a difference between empty configuration and factory default.

Pix to asa migration tool 8.4